Show Loop-Protection - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C
WITCHING OMMANDS
-
SHOW LOOP PROTECTION

show loop-protection

Overview Use this command to display the current loop protection setup for the device.
show loop-protection [interface <port-list>] [counters]
Syntax
Mode User Exec and Privileged Exec
Usage This command is used to display the current configuration and operation of the
Loop Protection feature
Examples To display the current configuration status, use the command:
awplus#
Figure 12-4: Example output from the show loop-protection command
awplus#show loop-protection

LDF Interval:
LDF Rx Window:
Fast Block: Disabled
Int Enabled
--------------------------------------------------------------------------
port1.0.1 Yes
port1.0.2 Yes
port1.0.3 Yes
...
To display the counter information, use the command:
awplus#
Figure 12-5: Example output from the show loop-protection counters
613-50157-01 Rev C
Parameter Description
interface
The interface selected for display.
<port-list>
A port, a port range, or an aggregated link.
counters
Displays counter information for loop protection.
show loop-protection
10
3
Action Status
vlan-dis Normal
vlan-dis Normal
vlan-dis Normal
show loop-protection counters
command
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Timeout
Timeout Remain
7 -
7 -
7 -
Rx port
-
-
-
382