Show Running-Config Interface - Allied Telesis IE340 Series Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT
-
SHOW RUNNING CONFIG INTERFACE

show running-config interface

Overview This command displays the current configuration of one or more interfaces on the
device.
You can optionally limit the command output to display only information for a
given protocol or feature. The features available depend on your device and will be
a subset of the features listed in the table below.
show running-config interface
Syntax
show running-config interface <interface-list>
show running-config interface <interface-list> <feature>
show running-config interface <interface-list> ip <feature>
show running-config interface <interface-list> ipv6 <feature>
C613-50631-01 Rev A
C
OMMANDS
Parameter
<interface-list>
cfm
dot1x
lacp
ip igmp
ip multicast
ip pim sparse-mode Displays running configuration for PIM-SM (Protocol
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
The interfaces or ports to display information about. An
interface-list can be:
• a VLAN (e.g. vlan2)
• a switchport (e.g. port1.0.4)
• a static channel group (e.g. sa2)
• a dynamic (LACP) channel group (e.g. po2)
• the loopback interface (lo)
• a continuous range of interfaces separated by a hyphen
(e.g. vlan10-20)
• a comma-separated list (e.g. vlan1,vlan10-20). Do not mix
interface types in a list.
The specified interfaces must exist.
Displays running configuration for CFM (Connectivity Fault
Management) for the specified interfaces.
Displays running configuration for 802.1X port
authentication for the specified interfaces.
Displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
Displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
Displays running configuration for general multicast
settings for the specified interfaces.
Independent Multicast - Sparse Mode) for the specified
interfaces.
187