Show Running-Config Interface - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT
-
SHOW RUNNING CONFIG INTERFACE

show running-config interface

Overview This command displays the current configuration of one or more interfaces on the
device.
show running-config interface [<interface-list>] [dot1x|ip
Syntax
igmp|ip multicast|ip pim dense-mode|ip pim sparse-mode|ipv6
rip|lacp|mstp|ospf|rip|rstp|stp]
Mode Privileged Exec and Global Configuration
Default Displays information for all protocols on all interfaces
Examples To display the current running configuration of your device for ports 1 to 4, use the
command:
awplus#
613-50157-01 Rev C
C
OMMANDS
Parameter
<interface-list>
dot1x
lacp
ip igmp
ip multicast
mstp
rstp
stp
show running-config interface port1.0.1-port1.0.4
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
Description
The interfaces or ports to display information about. An
interface-list can be:
• a VLAN (e.g. vlan2), a LAN port (e.g. port1.0.4), a static
channel group (e.g. sa2) or a dynamic (LACP) channel
group (e.g. po2)
• a continuous range of VLANs, ports, static channel
groups or dynamic (LACP) channel groups, separated by
a hyphen (e.g. vlan2-8, or port1.0.1-1.0.4, or sa1-2, or
po1-2)
• a comma-separated list of the above (e.g.
vlan2,vlan20-30). Do not mix interface types in a list.
The specified interfaces must exist.
Displays running configuration for 802.1X port
authentication for the specified interfaces.
Displays running configuration for LACP (Link Aggregation
Control Protocol) for the specified interfaces.
Displays running configuration for IGMP (Internet Group
Management Protocol) for the specified interfaces.
Displays running configuration for general multicast
settings for the specified interfaces.
Displays running configuration for MSTP (Multiple
Spanning Tree Protocol) for the specified interfaces.
Displays running configuration for RSTP (Rapid Spanning
Tree Protocol) for the specified interfaces.
Displays running configuration for STP (Spanning Tree
Protocol) for the specified interfaces.
117