Example: Qos Parameter Configuration For Qos Downstream Rate; Table 33: Shaping Rate And Shaping Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - QUALITY OF SERVICE CONFIGURATION GUIDE 2010-09-22 Configuration Manual

Example: QoS Parameter Configuration for QoS Downstream Rate

Configuring Traffic
Classes
Copyright © 2010, Juniper Networks, Inc.
For more information about configuring ANCP (L2C) parameters, see JunosE IP Services
Configuration Guide
aaa qos downstream-rate
controlled-interface-type
encapsulation vlan
instance-interface-type
ip address
node
qos-parameter
qos-adaptive-mode
qos-parameter-define
qos-profile
queue
shared-shaping-rate
subscriber-interface-type
traffic-class
vlan id
This example illustrates how to use parameters to control the downstream rate obtained
from ANCP.
In this example, the subscribers on the 0.1 access loop are configured on VLAN1. They
subscribe to voice, video, and data traffic with a bandwidth of 10 Mbps. Subscribers on
the 1.1 access loop are configured on VLAN2, and subscribe to 1 Mbps of data traffic.
Table 33 on page 287 lists the shaping mode and shaping rate information received by
the QoS downstream rate application upon access loop synchronization. The parameter
instances are created with these values.

Table 33: Shaping Rate and Shaping Mode

Shaping mode
Shaping rate
The QoS administrator configures the traffic classes for voice and video services.
Configure the traffic class named voice.
1.
Chapter 30: Configuring the Downstream Rate Using QoS Parameters
VLAN1 VLAN2
Cell Cell
10000000 bps 100000 bps
287