Initial Setup Configuration; Boot Nsm3000; Set Up Your Appliance - Juniper NETWORK AND SECURITY MANAGER NSM3000 - QUICK START REV 1 Quick Start Manual

Initial Setup Configuration

Boot NSM3000

Set Up Your Appliance

Copyright © 2010, Juniper Networks, Inc.
When you first turn on an unconfigured NSM3000 appliance, you need to enter basic
network and machine information through the serial console to make your appliance
accessible to the network. After entering these settings, you can continue configuring
the appliance using the CLI or the Web interface. You are not prompted for the initial
setup information again.
This section describes the required serial console setup and the tasks you need to perform
when connecting to your NSM3000 for the first time:
Boot NSM3000 on page 7
Set Up Your Appliance on page 7
To configure NSM3000 for the first time, you must attach your NSM3000 appliance to
a console terminal running an emulation utility such as HyperTerminal.
Configure a console terminal or terminal emulation utility to use the following serial
1.
connection parameters:
9600 bits per second
8-bit no parity (8N1)
1 stop bit
No flow control
Connect the terminal or laptop to the null modem serial cable plugged into the
2.
NSM3000 console port.
Turn on the NSM3000 appliance.
3.
When NSM3000 is powered on, the serial console displays diagnostic information
before proceeding to the boot countdown. When complete, the serial console displays
the login prompt terminal emulator.
NSMXpress.juniper.net login:
Enter admin as your default login name.
4.
Enter abc123 as your default password.
5.
Change your default password when prompted. Enter the default password first,
6.
followed by your new password. All passwords are case-sensitive.
This section provides the minimum information necessary to make your appliance active
on the network.
To set up your appliance either as a regional server or a central manager, follow these
steps:
Initial Setup Configuration
7