Ethernet Oam Lfm - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ethernet oam lfm

Syntax
Release Information
Description
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
[ no ] ethernet oam lfm
Command introduced in JunosE Release 11.1.0.
Enables 802.3ah Ethernet Operation, Administration, and Maintenance (OAM) link-fault
management on an interface. Enabling IEEE 802.3ah OAM functionality on a physical
interface automatically triggers the discovery process. The default discovery mode of
the OAM entity is active. The no version disables OAM link-fault management on the
interface.
NOTE: If you enable OAM on an interface without specifying other parameters
for the local OAM entity, such as the discovery mode for the OAM entity and
the interval at which OAM protocol data units (PDUs) are sent to the remote
peer, default values are assigned to all the attributes that are not manually
configured.
Interface Configuration
ethernet oam lfm mode on page 585
Guidelines for Configuring 802.3ah OAM Link-Fault Management
Configuring 802.3ah OAM Link-Fault Management
Chapter 6: E Commands
577