Figure 111: Testing The Inner Rails With The Extension Brackets; Figure 112: Verifying The Length Of The Extension Bracket - Allied Telesis x950 Series Installation Manual

Figure 111. Testing the Inner Rails with the Extension Brackets
5. Measure the distance from the front of the equipment rack to the front
of the inner rail. Refer to Figure 112. This should approximately match
the value you measured in "Measuring the Extension Bracket Lengths"
on page 176.
Figure 112. Verifying the Length of the Extension Bracket
6. If the extension brackets are the correct length, remove the inner
brackets from the outer brackets and go to "Installing the Inner Rails on
the Switch" on page 182.
7. If the brackets are not the correct length, repeat this procedure.
x950 Series Installation Guide for VCStack
181