Ipv6 Route - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6
IPV ROUTE

ipv6 route

Overview This command adds a static IPv6 route to the Routing Information Base (RIB). If this
route is the best route for the destination, then your device adds it to the
Forwarding Information Base (FIB). Your device uses the FIB to forward packets and
to advertise routes to neighbors.
The no variant of this command removes the static route.
ipv6 route <dest-prefix/length> {<gateway-ip>|<gateway-name>}
Syntax
[<src-prefix/length>] [<distvalue>] [description
<description>]
no ipv6 route <dest-prefix/length>
{<gateway-ip>|<gateway-name>} [<src-prefix/length>]
[<distvalue>]
Mode Global Configuration
Usage notes You can configure IPv6 static routes for Source Address Dependent Routing
(SADR) by providing a source prefix. In 'normal' routing, when the device searches
C613-50631-01 Rev A
Parameter
<dest-prefix/length>
<gateway-ip>
<gateway-name>
<src-prefix/length>
<distvalue>
description
<description>
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Description
Specifies the destination prefix.
The IPv6 address prefix uses the format
X:X::/prefix-length. The prefix-length is usually set
between 0 and 64.
Specifies the address of the gateway (or next
hop). The IPv6 address uses the format
X:X::X:X/Prefix-Length. The prefix-length is usually
set between 0 and 64.
Specifies the name of the interface for the
gateway (or next hop).
Specifies the source prefix. This is used for SADR -
see the Usage notes.
The IPv6 address prefix uses the format
X:X::/prefix-length. The prefix-length is usually set
between 0 and 64.
Specifies the administrative distance for the
route. Valid values are from 1 to 255. You can use
administrative distance to determine which
routes take priority over other routes. The route
with the lowest distance value is used.
A description to record the route's purpose. It can
be up to 80 printable ASCII characters long,
including spaces. The description does not affect
routing or forwarding decisions made by the
device. To see the description, use the command
show running-configuration.
987