Ipv6 Nd Other-Config-Flag - Allied Telesis IE340 Series Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND OTHER CONFIG FLAG

ipv6 nd other-config-flag

Overview Use this command to set the other stateful configuration flag (contained within
the router advertisement field) to be used for IPv6 address auto-configuration. This
flag is used to request the router to provide information in addition to providing
addresses.
Setting the
other-config-flag
Use no variant of this command to reset the value to the default.
ipv6 nd other-config-flag
Syntax
no ipv6 nd other-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface or a local loopback interface.
Usage notes To enable the transmission of router advertisements, you must apply the no
version of the
below.
Example To set the IPv6 other-config-flag on the VLAN interface vlan2, use the following
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
commands
ipv6 nd prefix
ipv6 nd managed-config-flag
C613-50631-01 Rev A
ipv6 nd managed-config-flag
will also be set.
ipv6 nd suppress-ra
configure terminal
interface vlan2
ipv6 nd other-config-flag
no ipv6 nd suppress-ra
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
command implies that the
command. This step is included in the example
ipv6 nd
973