Ipv6 Nd Other-Config-Flag - Allied Telesis AT-x510-28GTX Command Reference Manual

IP 6 C
V OMMANDS
6 - -
IPV ND OTHER CONFIG FLAG

ipv6 nd other-config-flag

Overview Use this command to set the other stateful configuration flag (contained within
the router advertisement field) to be used for IPv6 address auto-configuration. This
flag is used to request the router to provide information in addition to providing
addresses.
NOTE
Setting the
other-config-flag
Use no variant of this command to reset the value to the default.
Syntax ipv6 nd other-config-flag
no ipv6 nd other-config-flag
Default Unset
Mode Interface Configuration for a VLAN interface.
Usage Advertisement flags will not be transmitted unless you have applied the
suppress-ra
To set the IPv6 other-config-flag on the VLAN interface vlan4, use the following
Example
commands:
awplus#
awplus(config)#
awplus(config-if)#
awplus(config-if)#
Related ipv6 nd suppress-ra
Commands
ipv6 nd prefix
ipv6 nd managed-config-flag
C613-50102-01 REV C
:
ipv6 nd managed-config-flag
will also be set.
command. This step is included in the example below.
configure terminal
interface vlan4
ipv6 nd other-config-flag
no ipv6 nd suppress-ra
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
command implies that the ipv6 nd
ipv6 nd
774