Show Arp - Allied Telesis IE340 Series Command Reference Manual

IP A P
DDRESSING AND ROTOCOL

SHOW ARP

show arp
Overview Use this command to display entries in the ARP routing and forwarding table—the
ARP cache contains mappings of IP addresses to physical addresses for hosts. To
have a dynamic entry in the ARP cache, a host must have used the ARP protocol to
access another host.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show arp
Syntax
Mode User Exec and Privileged Exec
Usage notes Running this command with no additional parameters will display all entries in the
ARP routing and forwarding table.
Example To display all ARP entries in the ARP cache, use the following command:
awplus#
Output Figure 22-3: Example output from the show arp command
Table 23: Parameters in the output of the show arp command
Related arp
commands
clear arp-cache
show arp security
C613-50631-01 Rev A
C
OMMANDS
show arp
awplus#show arp
IP Address LL Address
192.168.27.10 192.168.4.1
192.168.27.100 0000.daaf.cd24
...
Parameter
IP Address
LL Address
Interface
Port
Type
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Interface
vlan1
vlan1
Meaning
IP address of the network device this entry maps to.
Hardware address of the network device.
Interface over which the network device is accessed.
Physical port that the network device is attached to.
Whether the entry is a static or dynamic entry. Static
entries are added using the
are learned from ARP request/reply message exchanges.
"Getting Started
Guide.
Port Type
port1.0.1 dynamic
port1.0.2 dynamic
arp command. Dynamic entries
909