Show Arp - Allied Telesis x510-28GTX Command Reference Manual

IP A P
DDRESSING AND ROTOCOL

SHOW ARP

show arp
Overview Use this command to display entries in the ARP routing and forwarding table—the
ARP cache contains mappings of IP addresses to physical addresses for hosts. To
have a dynamic entry in the ARP cache, a host must have used the ARP protocol to
access another host.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
show arp [security [interface [<interface-list>]]
Syntax
show arp [statistics [detail][interface [<interface-list>]]
Mode User Exec and Privileged Exec
Usage Running this command with no additional parameters will display all entries in the
ARP routing and forwarding table.
Example To display all ARP entries in the ARP cache, use the following command:
awplus#
Output Figure 21-3: Example output from the show arp command
awplus#show arp

IP Address MAC Address
192.168.10.2 0015.77ad.fad8
192.168.20.2 0015.77ad.fa48
192.168.1.100 00d0.6b04.2a42
C613-50170-01 Rev B
C
OMMANDS
Parameter
security
interface
<interface-list>
statistics
detail
show arp
Interface
vlan1
vlan2
vlan2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify the DHCP Snooping ARP security output option.
Specify an interface list for DHCP Snooping ARP security
output.
Specify a single Layer 3 interface name, or a range of
interfaces.
Specify brief DHCP Snooping ARP security statistics.
Specify detailed DHCP Snooping ARP security statistics.
Port
port1.0.1
port1.0.2
port1.0.6
"Getting Started
Guide.
Type 
dynamic
dynamic
static
802