Show Static-Channel-Group - Allied Telesis x510-28GTX Command Reference Manual

L A C
INK GGREGATION OMMANDS
- -
SHOW STATIC CHANNEL GROUP

show static-channel-group

Overview Use this command to display all configured static channel groups and their
corresponding member ports. Note that a static channel group is the same as a
static aggregator.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the action parameter of the
vlan-disable, the output will also show the VLANs on which thrashing is detected.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
available on our website at alliedtelesis.com.
show static-channel-group
Syntax
Mode User Exec and Privileged Exec
Example awplus#
Output Example output from show static-channel-group
Related static-channel-group
Commands
C613-50170-01 Rev B
show static-channel-group
% LAG Maximum
% LAG Static Maximum: 96
% LAG Dynamic Maximum: 32
% LAG Static Count
% LAG Dynamic Count
% LAG Total Count
% Static Aggregator: sa2
% Member:
port1.0.1
% Static Aggregator: sa3
% Member:
port1.0.2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
thrash-limiting
: 128
: 2
: 2
: 4
command is set to
"Getting Started
Guide, which is
721