Show Static-Channel-Group - Allied Telesis AT-IX5-28GPX Manual

L A C
INK GGREGATION OMMANDS
- -
SHOW STATIC CHANNEL GROUP

show static-channel-group

Overview Use this command to display all configured static channel groups and their
corresponding member ports. Note that a static channel group is the same as a
static aggregator.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the thrash limiting parameter of the
to vlan disable, the output will also show the VLANs on which thrashing is
detected.
For information on filtering and saving command output, see "Controlling "show"
Command Output" in the
and Configuration
Syntax
show static-channel-group
Mode User Exec and Privileged Exec
Example
awplus#
Output Figure 13-9: Example output from the show static-channel-group command
Related static-channel-group
Commands
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Guide.
show static-channel-group
% LAG Maximum
% LAG Static Maximum: 96
% LAG Dynamic Maximum: 32
% LAG Static Count
% LAG Dynamic Count
% LAG Total Count
% Static Aggregator: sa2
% Member:
port1.0.1
% Static Aggregator: sa3
% Member:
port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
"Getting Started with AlliedWare Plus" Feature Overview
: 128
: 2
: 2
: 4
thrash-limiting command is set
559