Spanning-Tree Mode - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S T C
PANNING REE OMMANDS
-
SPANNING TREE MODE

spanning-tree mode

Overview Use this command to change the spanning tree protocol mode on the device. The
spanning tree protocol mode on the device can be configured to either STP, RSTP
or MSTP.
spanning-tree mode {stp|rstp|mstp}
Syntax
Default The default spanning tree protocol mode on the device is RSTP.
Mode Global Configuration
Usage With no configuration, the device will have spanning tree enabled, and the
spanning tree mode will be set to RSTP. Use this command to change the spanning
tree protocol mode on the device. MSTP is VLAN aware, but RSTP and STP are not
VLAN aware. To enable or disable spanning tree operation, see the
enable
Examples To change the spanning tree mode from the default of RSTP to MSTP, use the
following commands:
awplus#
awplus(config)#
Related spanning-tree enable
Commands
613-50157-01 Rev C
command.
configure terminal
spanning-tree mode mstp
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
spanning-tree
500