Table of Contents
Advertisement
S
T
C
PANNING
REE
OMMANDS
-
SPANNING
TREE MODE
spanning-tree mode
Overview
Use this command to change the spanning tree protocol mode on the device. The
spanning tree protocol mode on the device can be configured to either STP, RSTP
or MSTP.
spanning-tree mode {stp|rstp|mstp}
Syntax
Default
The default spanning tree protocol mode on the device is RSTP.
Mode
Global Configuration
Usage
With no configuration, the device will have spanning tree enabled, and the
spanning tree mode will be set to RSTP. Use this command to change the spanning
tree protocol mode on the device. MSTP is VLAN aware, but RSTP and STP are not
VLAN aware. To enable or disable spanning tree operation, see the
enable
Examples
To change the spanning tree mode from the default of RSTP to MSTP, use the
following commands:
awplus#
awplus(config)#
Related
spanning-tree enable
Commands
C613-50103-01 REV A
command.
configure terminal
spanning-tree mode mstp
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
spanning-tree
583
Advertisement
Table of Contents
