Switchport Private-Vlan Mapping - Allied Telesis AT-x510-28GTX Command Reference Manual

VLAN C
OMMANDS
-
SWITCHPORT PRIVATE VLAN MAPPING

switchport private-vlan mapping

Overview Use this command to associate a primary VLAN and a set of secondary VLANs to a
promiscuous port.
Use the no variant of this to remove all the association of secondary VLANs to
primary VLANs for a promiscuous port.
Syntax switchport private-vlan mapping <primary-vlan-id> add
<secondary-vid-list>
switchport private-vlan mapping <primary-vlan-id> remove
<secondary-vid-list>
no switchport private-vlan mapping
Mode Interface Configuration
Usage This command can be applied to a switch port or a static channel group, but not a
dynamic (LACP) channel group. LACP channel groups (dynamic/LACP
aggregators) cannot be promiscuous ports in private VLANs.
awplus#
Examples
awplus(config)#
awplus(config-if)#
awplus(config-if)#
awplus(config-if)#
Related switchport mode private-vlan
Commands
C613-50102-01 REV C
Parameter
<primary-vlan-id>
<secondary-vid-list> VLAN ID of the secondary VLAN (either isolated or
configure terminal
interface port1.0.2
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Description
VLAN ID of the primary VLAN.
community), or a range of VLANs, or a comma-separated
list of VLANs and ranges.
switchport private-vlan mapping 2 add 3-4
switchport private-vlan mapping 2 remove 3-4
no switchport private-vlan mapping
518