Switchport Mode Private-Vlan - Allied Telesis IE340 Series Command Reference Manual

VLAN C
OMMANDS
-
SWITCHPORT MODE PRIVATE VLAN

switchport mode private-vlan

Overview Use this command to make a Layer 2 port a private VLAN host port or a
promiscuous port.
Use the no variant of this command to remove the configuration.
Syntax switchport mode private-vlan {host|promiscuous}
no switchport mode private-vlan {host|promiscuous}
Mode Interface Configuration
Examples To configure host mode, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To configure promiscuous mode, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove promiscuous mode, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related switchport private-vlan mapping
commands
C613-50631-01 Rev A
Parameter Description
host
This port type can communicate with all other host ports assigned to
the same community VLAN, but it cannot communicate with the
ports in the same isolated VLAN. All communications outside of this
VLAN must pass through a promiscuous port in the associated
primary VLAN.
promiscuous
A promiscuous port can communicate with all interfaces, including
the community and isolated ports within a private VLAN.
configure terminal
interface port1.0.2
configure terminal
interface port1.0.3
configure terminal
interface port1.0.3
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
switchport mode private-vlan host
switchport mode private-vlan promiscuous
no switchport mode private-vlan promiscuous
662