Switchport Mode Access - Allied Telesis AT-IX5-28GPX Manual

VLAN C
OMMANDS

SWITCHPORT MODE ACCESS

switchport mode access
Overview Use this command to set the switching characteristics of the port to access mode.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
Syntax
switchport mode access [ingress-filter {enable|disable}]
Default By default, ports are in access mode with ingress filtering on.
Usage Use access mode to send untagged frames only.
Mode Interface Configuration
Example
awplus#
awplus(config)#
awplus(config-if)#
Validation show interface switchport
Command
C613-50057-01 REV A Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Set the ingress filtering for the received frames.
ingress-filter
Turn on ingress filtering for received frames. This is the default.
enable
Turn off ingress filtering to accept frames that do not meet the
disable
classification criteria.
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
switchport mode access ingress-filter enable
431