Switchport Mode Access - Allied Telesis IE220 Series Manual

VLAN C
OMMANDS

SWITCHPORT MODE ACCESS

switchport mode access
Overview Use this command to set the switching characteristics of the port to access mode.
Received frames are classified based on the VLAN characteristics, then accepted or
discarded based on the specified filtering criteria.
switchport mode access [ingress-filter {enable|disable}]
Syntax
Default By default, ports are in access mode with ingress filtering on.
Usage notes Use access mode to send untagged frames only.
Mode Interface Configuration
awplus#
Example
awplus(config)#
awplus(config-if)#
Related show interface switchport
Commands
Command Version 5.5.0-1.3: Support for up to 5 VLANs added to AR1050V
changes
C613-50644-01 Rev B
Parameter Description
ingress-filter
Set the ingress filtering for the received frames.
enable
Turn on ingress filtering for received frames. This is the default.
disable
Turn off ingress filtering to accept frames that do not meet the
classification criteria.
configure terminal
interface port1.0.2
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
switchport mode access ingress-filter enable
611