Switchport Port-Security Maximum - Allied Telesis x510-28GTX Command Reference Manual

S C
WITCHING OMMANDS
-
SWITCHPORT PORT SECURITY MAXIMUM

switchport port-security maximum

Overview Use this command to set the maximum number of MAC addresses that each port
can learn.
Use the no variant of this command to unset the maximum number of MAC
addresses that each port can learn. This is same as setting the maximum number
to 0. This command also resets the intrusion list table.
If a new MAC is seen on a port with port security enabled and the MAC is statically
configured for another port, a violation is triggered. The maximum learn limit will
be ignored and the specified intrusion action for the port will be carried out.
switchport port-security maximum <0-256>
Syntax
no switchport port-security maximum
Mode Interface Configuration
To learn 3 MAC addresses on port1.0.4, use the following commands:
Examples
awplus#
awplus(config)#
awplus(config-if)#
To remove the MAC learning limit on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
Related clear port-security intrusion
Commands
show port-security interface
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security violation
C613-50170-01 Rev B
Parameter
maximum <0-256>
configure terminal
interface port1.0.4
configure terminal
interface port1.0.4
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Description
Specify the maximum number of addresses to learn.
switchport port-security maximum 3
no switchport port-security maximum
561