Switchport Port-Security Maximum - Allied Telesis AT-IX5-28GPX Manual

S C
WITCHING OMMANDS
-
SWITCHPORT PORT SECURITY MAXIMUM

switchport port-security maximum

Overview Sets the maximum MAC address that each port can learn.
Use the no variant of this command to unset the maximum number of MAC
addresses that each port can learn. This is same as setting the maximum number
to 0. This command also resets the intrusion list table.
If a new MAC is seen on a port with port security enabled and the MAC is statically
configured for another port, a violation is triggered. The maximum learn limit will
be ignored and the specified intrusion action for the port will be carried out.
Syntax
switchport port-security maximum <0-256>
no switchport port-security maximum
Mode Interface Configuration
Examples To learn 3 MAC addresses on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
To remove the MAC learning limit on port1.0.4, use the following commands:
awplus#
awplus(config)#
awplus(config-if)#
408 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Maximum number of address to learn.
maximum
Maximum number of address to learn.
<0-256>
configure terminal
interface port1.0.4
configure terminal
interface port1.0.4
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
switchport port-security maximum 3
no switchport port-security maximum
C613-50057-01 REV A