Switchport Enable Vlan - Allied Telesis AT-IX5-28GPX Manual

VLAN C
OMMANDS

SWITCHPORT ENABLE VLAN

switchport enable vlan
Overview This command enables the VLAN on the port manually once disabled by certain
actions, such as QSP (QoS Storm Protection) or EPSR (Ethernet Protection
Switching Ring). Note that if the VID is not given, all disabled VLANs are re-enabled.
Syntax
switchport enable vlan [<1-4094>]
Mode Interface Configuration
Example To re-enable the port1.0.1 from VLAN 1:
awplus#
awplus(config)#
awplus(config-if)#
Related show mls qos interface storm-status
Commands
storm-window
430 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
Parameter Description
Re-enables the VLAN on the port.
vlan
VLAN ID.
<1-4094>
configure terminal
interface port1.0.1
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
switchport enable vlan 1
C613-50057-01 REV A