Switchport Enable Vlan - Allied Telesis AT-x510-28GTX Command Reference Manual

VLAN C
OMMANDS

SWITCHPORT ENABLE VLAN

switchport enable vlan
Overview This command enables the VLAN on the port manually once disabled by certain
actions, such as QSP (QoS Storm Protection) or EPSR (Ethernet Protection
Switching Ring). Note that if the VID is not given, all disabled VLANs are re-enabled.
switchport enable vlan [<1-4094>]
Syntax
Mode Interface Configuration
Example To re-enable the port1.0.1 from VLAN 1:
awplus#
awplus(config)#
awplus(config-if)#
Related show mls qos interface storm-status
Commands
storm-window
C613-50102-01 REV C
Parameter Description
vlan
Re-enables the VLAN on the port.
<1-4094>
VLAN ID.
configure terminal
interface port1.0.1
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
switchport enable vlan 1
509