Show Port-Security Intrusion - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S C
WITCHING OMMANDS
-
SHOW PORT SECURITY INTRUSION

show port-security intrusion

Overview Use this command to show the intrusion list. If the port is not specified, the entire
intrusion table is shown.
show port-security intrusion [interface <port>]
Syntax
Mode Privileged Exec
To see the intrusion list on port1.0.1, use the following command:
Example
awplus#
Output Figure 12-11: Example output from the show port-security intrusion command
Related clear port-security intrusion
Commands
show port-security interface
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
613-50157-01 Rev C
Parameter Description
interface
Specify a port
<port>
The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
show port-security intrusion interface port1.0.1
for port 1.0.1
Port Security Intrusion List 
Interface: port1.0.1 -3 intrusion(s) detected 
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
395