Show Port-Security Intrusion - Allied Telesis IE220 Series Manual

S C
WITCHING OMMANDS
-
SHOW PORT SECURITY INTRUSION

show port-security intrusion

Overview Use this command to show the intrusion list. If the port is not specified, the entire
intrusion table is shown.
show port-security intrusion [interface <port>]
Syntax
Mode Privileged Exec
Example To see the intrusion list on port1.0.2, use the following command:
awplus#
Output Figure 15-11: Example output from the show port-security intrusion command
Related clear port-security intrusion
commands
show port-security interface
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
C613-50644-01 Rev B
Parameter Description
interface
Specify a port
<port>
Specify the switch port to display information about, e.g.
port1.0.4.
show port-security intrusion interface port1.0.2
for port1.0.2
Port Security Intrusion List 
Interface: port1.0.2 -3 intrusion(s) detected 
11-22-33-44-55-04 11-22-33-44-55-06 11-22-33-44-55-08
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
565