Show Port-Security Interface - Allied Telesis IE340 Series Command Reference Manual

S C
WITCHING OMMANDS
-
SHOW PORT SECURITY INTERFACE

show port-security interface

Overview Use this command to show the current port-security configuration and status.
show port-security interface <port>
Syntax
Mode Privileged Exec
Example To see the port-security status on port1.0.2, use the following command:
awplus#
Output Figure 15-10: Example output from the show port-security interface command
Related clear port-security intrusion
commands
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
C613-50631-01 Rev A
Parameter Description
<port>
Specify the switch port to display information about, e.g.
port1.0.4.
show port-security interface port1.0.2
Port Security configuration
Security Enabled
Port Status
Violation Mode
Aging
Maximum MAC Addresses
Total MAC ddresses
Lock Status
Security Violation Count
Last Violation Source Address : None
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
: YES
: ENABLED
: TRAP
: OFF
: 3
: 1
: UNLOCKED
: 0
614