Show Port-Security Interface - Allied Telesis x310-26FT Command Reference Manual

S C
WITCHING OMMANDS
-
SHOW PORT SECURITY INTERFACE

show port-security interface

Overview Use this command to show the current port-security configuration and the switch
port status.
show port-security interface <port>
Syntax
Mode Privileged Exec
Example To see the port-security status on port1.0.1, use the following command:
awplus#
Output Figure 13-10: Example output from the show port-security interface command
Related clear port-security intrusion
Commands
show port-security intrusion
switchport port-security
switchport port-security aging
switchport port-security maximum
switchport port-security violation
C613-50103-01 REV A
Parameter Description
<port>
The port to display information about. The port may be a switch
port (e.g. port1.0.4), a static channel group (e.g. sa3), or a
dynamic (LACP) channel group (e.g. po4).
show port-security interface port1.0.1
Port Security configuration
Security Enabled
Port Status
Violation Mode
Aging
Maximum MAC Addresses
Total MAC ddresses
Lock Status
Security Violation Count
Last Violation Source Address : None
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
: YES
: ENABLED
: TRAP
: OFF
: 3
: 1
: UNLOCKED
: 0
469