Loop-Protection Action - Allied Telesis x310-26FT Command Reference Manual

S C
WITCHING OMMANDS
-
LOOP PROTECTION ACTION

loop-protection action

Overview Use this command to specify the protective action to apply when a network loop
is detected on an interface.
Use the no variant of this command to reset the loop protection actions to the
default action, vlan-disable, on an interface.
Syntax loop-protection action
{link-down|log-only|port-disable|vlan-disable|none}
no loop-protection action
Default loop-protection action vlan-disable
Mode Interface Configuration
Usage See the "Loop Protection" section in the
Configuration Guide
information prior to applying this command.
To disable the interface port1.0.4 and bring the link down when a network
Example
loop is detected, use the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related loop-protection loop-detect
Commands
loop-protection timeout
show loop-protection
thrash-limiting
C613-50103-01 REV A
Parameter Description
link-down
Block all traffic on a port (or aggregated link) that detected the
loop, and take down the link.
log-only
Details of loop conditions are logged. No action is applied to the
port (or aggregated link).
port-disable
Block all traffic on interface for which the loop occurred, but keep
the link in the up state.
vlan-disable
Block all traffic for the VLAN on which the loop traffic was
detected. Note that setting this parameter will also enable ingress
filtering. This is the default action.
none
Applies no protective action.
for relevant conceptual, configuration, and overview
configure terminal
interface port1.0.4
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
Switching Feature Overview and
loop-protection action link-down
439