Table of Contents
Advertisement
I
T
C
NTERFACE
ESTING
OMMANDS
SERVICE TEST
service test
Overview
This command puts the device into the interface testing state, ready to begin
testing. After entering this command, enter Interface Configuration mode for the
desired interfaces and enter the command
Do not test interfaces on a device that is part of a live network—disconnect the
device first.
Use the no variant of this command to stop the test service.
service test
Syntax
no service test
Mode
Global Configuration
Example
To put the device into a test state, use the command:
awplus(config)#
Related
test interface
Commands
C613-50103-01 REV A
service test
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
test
interface.
414
Advertisement
Table of Contents
