Displaying Port Settings; Displaying Speed And Duplex Settings; Displaying Port Status; Figure 45: Show Interface Status Command - Allied Telesis AT-9000 Series User Manual

Displaying Port Settings

Displaying Speed
and Duplex
Settings
Port
port1.0.18
port1.0.20
Displaying Port
Status
There are several ways to display port settings. See the following:
"Displaying Speed and Duplex Settings" on page 187

"Displaying Port Status" on page 187

"Displaying Port Configuration" on page 188

To display the speed and duplex mode settings of the ports, use the
SHOW INTERFACE STATUS command in the Privileged Exec mode.
Here is the format:
show interface [
This example of the command displays the speed and duplex mode
settings for ports 18 and 20:
awplus# show interface port1.0.18,port1.0.20 status
Here is an example of the information the command displays.
Name Status
Port_01 down
Port_02 up
Figure 45. SHOW INTERFACE STATUS Command
The columns are described in Table 15 on page 227. For a description of
the command, see "SHOW INTERFACE STATUS" on page 227.
To display the current status of the ports on the switch, use the SHOW
INTERFACE command in the Privileged Exec mode. Here is the format:
show interface [
This example displays the settings for ports 1 and 2:
awplus# show interface port1.0.1,port1.0.2
See Figure 46 on page 188 for an example of the display.
port
] status
Vlan Duplex Speed Type
3 half 100
11 auto auto
port ]
AT-9000 Switch Command Line User's Guide
10/100/1000Base-T
10/100/1000Base-T
187