Table of Contents
Advertisement
F
C
M
ILE AND
ONFIGURATION
ANAGEMENT
SHOW BOOT
show boot
Overview
This command displays the current boot configuration. We recommend that the
currently running release is set as the current boot image.
show boot
Syntax
Mode
Privileged Exec
Example
To show the current boot configuration, use the command:
awplus#
Output
Figure 2-8:
Table 1: Parameters in the output of the show boot command
C613-50103-01 REV A
C
OMMANDS
show boot
Example output from the show boot command when the current
boot config is on a USB storage device
awplus#show boot
Boot configuration
----------------------------------------------------------------
Current software
Current boot image : usb:/x310-5.4.6-1.1.rel
Backup
boot image : flash:/x310-5.4.6-0.1.rel
Default boot config: flash:/default.cfg
Current boot config: usb:/my.cfg (file exists)
Backup
boot config: flash:/backup.cfg (file not found)
Autoboot status
Parameter
Current software
Current boot image
Backup boot image
Default boot
config
Current boot
config
Command Reference for x310 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
: x310-5.4.6-1.1.rel
: enabled
Description
The current software release that the device is using.
The boot image currently configured for use during the
next boot cycle.
The boot image to use during the next boot cycle if the
device cannot load the main image.
The default startup configuration file. The device loads
this configuration script if no file is set as the startup-
config file.
The configuration file currently configured as the
startup-config file. The device loads this configuration file
during the next boot cycle if this file exists.
134
Advertisement
Table of Contents
