Show Boot - Allied Telesis x510-28GTX Command Reference Manual

F C M
ILE AND ONFIGURATION ANAGEMENT

SHOW BOOT

show boot
Overview This command displays the current boot configuration. We recommend that the
currently running release is set as the current boot image.
show boot
Syntax
Mode Privileged Exec
Example To show the current boot configuration, use the command:
awplus#
Output Figure 2-8:
Table 2-1: Parameters in the output from show boot
C613-50170-01 Rev B
C
OMMANDS
show boot
Example output from show boot when the current boot config is
on a USB storage device

awplus#show boot
Boot configuration
----------------------------------------------------------------
Current software
Current boot image : usb:/x510-5.4.7-1.1.rel
Backup boot image : flash:/x510-5.4.7-0.1.rel
Default boot config: flash:/default.cfg
Current boot config: usb:/my.cfg (file exists)
Backup boot config: flash:/backup.cfg (file not found)
Autoboot status
Parameter
Current software
Current boot image
Backup boot image
Default boot
config
Current boot
config
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
: x510-5.4.7-1.1.rel
: enabled
Description
The current software release that the device is using.
The boot image currently configured for use during the
next boot cycle.
The boot image to use during the next boot cycle if the
device cannot load the main image.
The default startup configuration file. The device loads
this configuration script if no file is set as the startup-
config file.
The configuration file currently configured as the
startup-config file. The device loads this configuration file
during the next boot cycle if this file exists.
142