Equipment Loopback - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
equipment loopback
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
equipment { customer | network } loopback
no equipment
Command introduced before JunosE Release 7.1.0.
Enables or disables the router's ability to be placed in loopback by a remote device
connected on a CT3 or T3 interface. The no version disables the router's ability to be
placed in loopback by the remote device.
customer—Enables the router to enter into loopback when it receives an appropriate
signal from the remote interface
network—Disables the router's ability to enter into loopback when it receives an
appropriate signal from the remote interface
Controller Configuration
Chapter 6: E Commands
573
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers