H3C MSR 20-20 Command Reference Manual page 277

Msr 20/30/50 series routers
Hide thumbs Also See for MSR 20-20:
Table of Contents

Advertisement

data: Sets information included in MDL messages. Among all types of
information, EIC, LIC, FIC, and unit are defined for all types of MDL messages; PFI
is only for path MDL messages; port number is only for idle signal messages; and
generator number is only for test signal messages.
eic string: Equipment identification code, a string of 1 to 10 characters. The
default EIC is line.
lic string: Location identification code, a string of 1 to 11 characters. The default
LIC is line.
fic string: Frame identification code, a string of 1 to 10 characters. The default FIC
is line.
unit string: Unit, a string of 1 to 6 characters. The default unit is line.
pfi string: Path facility identification, a string in the range 1 to 38 characters. The
default PFI is line.
port-no string: Port number, a string in the range 1 to 38 characters. The default
port number is line.
gen-no string: Generator number, a string of 1 to 38 characters. The default
generator number is line.
generate: Sends specified information with MDL messages, which can be path,
idle signal, and/or test signal regularly.
Description
Use the
interface.
Use the
Use the
messages.
Use the
messages.
Use the
MDL is a channel formed by using the three C-bits in the fifth subframe in C-bit
framing. According to ANSI T1.107a, it is used to transmit three types of
maintenance messages, path, idle signal, and test signal, and its data frame
format is LAPD.
At the startup of your router, MDL message detection and sending are disabled on
CT3 interfaces and the default MDL message information applies.
Example
# Enable MDL detection on CT3 interface T3 2/0.
<Sysname> system-view
[Sysname] interface t3 2/0
[Sysname-T3 2/0] mdl detect
command to configure MDL message detection/sending on the CT3
mdl
undo mdl
command to remove the MDL settings.
command to disable the CT3 interface to detect MDL
undo mdl detect
command to disable the CT3 interface to send MDL
undo mdl generate
command to restore the default.
undo mdl data
277

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr 20-21Msr 30-16Msr 30-20Msr 30-40Msr 30-60Msr 50 ... Show all

Table of Contents