Loopback (Ct3 Interface View); Mdl (Ct3 Interface View) - H3C MSR 20-20 Command Reference Manual

276 C 17: F
HAPTER UNDAMENTAL
Examples

loopback (CT3 interface view)

Syntax
View
Parameter
Description
Example

mdl (CT3 interface view)

Syntax
View
Parameter
CT3 I C
NTERFACE ONFIGURATION
# Configure T3 2/0 interface to operate in the FT3 mode, setting the DSU mode to
1 and the subrate to 3000 kbps.
<Sysname> system-view
[Sysname] controller t3 2/0
[Sysname-T3 2/0] using t3
[Sysname-T3 2/0] ft3 dsu-mode 1
[Sysname-T3 2/0] ft3 subrate 3000
loopback { local | payload | remote }
undo loopback
CT3 interface view
local: Enables internal loopback on the CT3 interface.
payload: Enables external payload loopback on the CT3 interface.
remote: Enables external loopback on the CT3 interface.
Use the command to configure the loopback mode for a CT3 interface.
loopback
Use the
undo loopback
By default, loopback is disabled on CT3 interfaces.
Loopback is intended for test use. Disable it otherwise.
If a CT3 interface encapsulated with PPP is placed in a loopback, it is normal that
the state of the link layer protocol is reported down.
# Enable internal loopback on interface T3 2/0.
<Sysname> system-view
[Sysname] interface t3 2/0
[Sysname-T3 2/0] loopback local
mdl { detect | data { eic string | fic string | | gen-no string | lic string | pfi string |
port-no string | unit string } | generate { idle-signal | path | test-signal } }
undo mdl [detect | data [ eic | fic | gen-no | lic | pfi | port-no | unit ] | generate
[idle-signal | path | test-signal ] ]
CT3 interface view
detect: Enables periodical maintenance data link (MDL) message detection.
C
OMMANDS
command to disable loopback.