Display Controller T3 - H3C MSR 20-20 Command Reference Manual

Example

display controller t3

Syntax
View
Parameter
Description
Example
# Apply 32-bit CRC to a serial interface formed on interface T3 2/0 in
unchannelized mode.
<Sysname> system-view
[Sysname] controller t3 2/0
[Sysname-T3 2/0] using t3
[Sysname-T3 2/0] quit
[Sysname] interface serial 2/0/0:0
[Sysname-Serial2/0/0:0] crc 32
# Apply 16-bit CRC to a serial interface formed on interface CT3 2/0 in
channelized mode.
<Sysname> system-view
[Sysname] controller t3 2/0
[Sysname-T3 2/0] t1 2 channel-set 4 timeslot-list 5-11
[Sysname-T3 2/0] quit
[Sysname] interface serial 2/0/2:4
[Sysname-Serial2/0/2:4] crc 16
display controller t3 [ interface-number ]
Any view
interface-number: CT3 interface number. In conjunction with the t3 keyword, it
specifies a CT3 interface.
Use the
display controller t3
specified or all CT3 interfaces.
In addition to the state information about the CT3 interface, the command
displays information about each T1 line on the CT3 interface if the interface is
working in CT3 mode.
# Display information about interface T3 2/0.
<Sysname> display controller t3 2/0
T3 2/0 current state :UP
Description : T3 2/0 Interface
sic Configuration:
Work mode is CT3, cable length is 49 feet.
Frame-format is C-BIT Parity, line code is B3ZS.
Source clock is slave, loopback is not set.
Alarm state:
Receiver alarm state is none.
MDL state:
No message is sent now.
Message data elements:
EIC: line, LIC: line, FIC: line, UNIT: line
FI: line, PORT_NO: line, GEN_NO: line
Periodical detection is disabled.
FEAC state:
command to display state information about one
269