268
C
17: F
HAPTER
UNDAMENTAL
Example
controller t3
Syntax
View
Parameter
Description
Related command:
Example
crc
Syntax
View
Parameter
Description
Related command:
CT3 I
C
NTERFACE
ONFIGURATION
# Use the internal clock as the clock source on CT3 interface T3 2/0.
<Sysname> system-view
[Sysname] interface t3 2/0
[Sysname-T3 2/0] clock master
controller t3 interface-number
System view
interface-number: CT3 interface number.
Use the
controller t3
display controller t3.
# Enter the view of interface T3 2/0.
<Sysname> system-view
[Sysname] controller t3 2/0
[Sysname-T3 2/0]
crc { 16 | 32 | none }
undo crc
Synchronous serial interface view
16: Adopts 16-bit CRC.
32: Adopts 32-bit CRC.
none: Adopts no CRC.
Use the
crc
command to configure CRC mode for the serial interface formed on
CT3 interfaces.
Use the
command to restore the default, that is, 16-bit CRC.
undo crc
These two commands apply to serial interfaces formed on T3 channels, T1
channels, and the interfaces formed by binding slots of T1 channels.
t1 channel-set, t1 unframed, using (CT3 interface view).
C
OMMANDS
command to enter CT3 interface view.