Dhcp Client Configuration Commands; Display Dhcp Client; Chapter 3 Dhcp Client Configuration Commands - H3C S7500E Series Command Manual

Hide thumbs Also See for S7500E Series:

Table of Contents

Command Manual – DHCP

H3C S7500E Series Ethernet Switches

The DHCP client configuration is supported only on VLAN interfaces.

When multiple VLAN interfaces having the same MAC address use DHCP for IP

address acquisition via a relay agent, the DHCP server cannot be the Windows

2000 Server or Windows 2003 Server.

You are not recommended to enable both the DHCP client and the DHCP Snooping

on the same device. Otherwise, DHCP Snooping entries may fail to be generated,

or the DHCP client may fail to obtain an IP address.

3.1 DHCP Client Configuration Commands

display dhcp client [ verbose ] [ interface interface-type interface-number ]

verbose: Specifies verbose DHCP client information to be displayed.

interface interface-type interface-number: Specifies an interface of which to display

DHCP client information.

Use the display dhcp client command to display DHCP client information. If no

interface interface-type interface-number is specified, DHCP client information of all

interfaces will be displayed.

# Display DHCP client information of all interfaces.

<Sysname> display dhcp client

Vlan-interface1 DHCP client information:

Current machine state: BOUND

Chapter 3 DHCP Client Configuration Commands

Table of Contents