Figure 59: Lowering The Power Cord Retaining Clip; Figure 60: Connecting The Power Cord To An Ac Power Source - Allied Telesis x330 Series Installation Manual

3. Lower the power cord retaining clip to secure the cord to the switch.
Refer to Figure 59.
Figure 59. Lowering the Power Cord Retaining Clip
4. Connect the power cord to an appropriate AC power source. Refer to
Figure 60.
Figure 60. Connecting the Power Cord to an AC Power Source
Note
The illustration shows a North American power cord. Your power
cord may be different.
5. Wait one minute for the switch to start the AlliedWare Plus
management software.
6. Go to "Starting a Local Management Session" on page 98.
x330 Series Installation Guide for Standalone Switches
97