Table of Contents
Advertisement
Chapter 6: Configuring Switches for Stacking
156
Figure 98. Connecting the Power Cord to an AC Power Source
Note
The illustration shows the North American power cord. Your power
cord may be different.
Note
The power cords included with SBxPWRSYS2 Power Supplies for
100-125 VAC installations have 20 Amp, 125 V NEMA 5-20P plugs.
The plugs require NEMA 5-20R receptacles. Refer to Figure 29 on
page 82.
4. If the switch has two power supplies, repeat this procedure to connect
a power cord to the second power supply.
5. Wait two minutes for the switch to initialize its management software.
Afterwards, go to "Configuring the Master Switch" on page 160 or
"Configuring Member Switches" on page 166.
Advertisement
Table of Contents
