Displaying The Hardware Status And Alliedware Plus Version Number; Figure 66: Disconnecting The Power Cord From The Ac Power Source - Allied Telesis x330-52GTX Installation Manual

Displaying the Hardware Status and AlliedWare Plus Version Number

This section contains the procedure for displaying the version number of
the AlliedWare Plus management software on the switch. All of the
switches in a stack must have the same version of the management
software. You should perform this procedure on the switches individually,
before building the stack.
If you have already started a local management session on the switch,
start with step 4. Otherwise, start with step 1. To view the management
software version number, perform the following procedure:
1. Power on one of the switches. Refer to "Powering On the Switch" on
page 110.
2. Wait several minute for the switch to initialize the AlliedWare Plus
management software.
3. Start a local management session on the switch. Refer to "Starting a
Local Management Session" on page 112.
4. In the User Exec or Privileged Exec mode, enter the SHOW SYSTEM
ENVIRONMENT command. The components should have the status
"OK" in the Status column of the screen output.
5. In the User Exec mode, enter either the SHOW SYSTEM or SHOW
VERSION command.
6. Write down the Software Version value from the screen output in the
Firmware Version Number column in the "VCStack Worksheet" on
page 60.
7. If you need to upgrade the software on the switch, refer to the Software
Reference for x330 Series Switches, AlliedWare Operating System at
www.alliedtelesis.com.
8. Power off the switch by disconnecting its AC power cord from the AC
power source. Refer to Figure 66.
Figure 66. Disconnecting the Power Cord from the AC Power Source
x330 Series Installation Guide for Virtual Chassis Stacking
115