Arp (Ip Address Mac) - Allied Telesis AT-IX5-28GPX Manual

IP A P
DDRESSING AND ROTOCOL
(IP MAC)
ARP ADDRESS

arp (IP address MAC)

Overview This command adds a static ARP entry to the ARP cache. This is typically used to
add entries for hosts that do not support ARP or to speed up the address resolution
function for a host. The ARP entry must not already exist. Use the alias parameter
to allow your device to respond to ARP requests for this IP address.
The no variant of this command removes the static ARP entry. Use the
arp-cache
Syntax
arp <ip-addr> <mac-address> [<port-number>] [alias]
no arp <ip-addr>
Mode Global Configuration
Examples To add the IP address 10.10.10.9 with the MAC address 0010.2533.4655 into the
ARP cache, and have your device respond to ARP requests for this address, use the
commands:
awplus#
awplus(config)#
Related clear arp-cache
Commands
ip proxy-arp
show arp
606 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
C
OMMANDS
command to remove the dynamic ARP entries in the ARP cache.
Parameter
<ip-addr>
<mac-address>
<port-number>
alias
configure terminal
arp 10.10.10.9 0010.2355.4566 alias
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
Description
IPv4 address of the device you are adding
as a static ARP entry.
MAC address of the device you are adding as a static ARP
entry, in hexadecimal notation with the format
HHHH.HHHH.HHHH.
The port number associated with the IP address. Specify this
when the IP address is part of a VLAN.
Allows your device to respond to ARP requests for the IP
address. Proxy ARP must be enabled on the interface before
using this parameter.
clear
C613-50057-01 REV A