Show Etherchannel - Allied Telesis AT-x510-28GTX Command Reference Manual

L A C
INK GGREGATION OMMANDS

SHOW ETHERCHANNEL

show etherchannel
Overview Use this command to display information about a LACP channel specified by the
channel group number.
The command output also shows the thrash limiting status. If thrash limiting is
detected and the action parameter of the
vlan-disable, the output will also show the VLANs on which thrashing is detected.
For information on filtering and saving command output, see the
with AlliedWare Plus" Feature Overview and Configuration
available on our website at alliedtelesis.com.
show etherchannel [<1-32>]
Syntax
Mode User Exec and Privileged Exec
awplus#
Example
Output Figure 17-3: Example output from show etherchannel
awplus#
Example
Output Figure 17-4: Example output from show etherchannel for a particular channel
C613-50102-01 REV C
Parameter Description
<1-32>
Channel-group number.
show etherchannel
awplus#show etherchannel
LAG Maximum
LAG Static Maximum: 96
LAG Dynamic Maximum: 32
LAG Static Count
LAG Dynamic Count
LAG Total Count
Lacp Aggregator: po1
Member:
port1.0.5
port1.0.6
show etherchannel 1
awplus#show etherchannel 1
Aggregator po1 (4601)
Mac address: 00:00:00:00:00:00
Admin Key: 0001 - Oper Key 0000
Receive link count: 0 - Transmit link count: 0
Individual: 0 - Ready: 0
Partner LAG: 0x0000,00-00-00-00-00-00
Link: port1.0.1 (5001) disabled
Link: port1.0.2 (5002) disabled
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
thrash-limiting
: 128
: 0
: 1
: 1
command is set to
"Getting Started
Guide, which is
635