Spanning-Tree Edgeport (Rstp And Mstp) - Allied Telesis AT-IX5-28GPX Manual

S T C
PANNING REE OMMANDS
- (RSTP
SPANNING TREE EDGEPORT

spanning-tree edgeport (RSTP and MSTP)

Overview Use this command to set a port as an edge-port.
Use this command for RSTP or MSTP.
This command has the same effect as the
but the configuration displays differently in the output of some show commands.
Use the no variant of this command to set a port to its default state (not an
edge-port).
Syntax
spanning-tree edgeport
no spanning-tree edgeport
Default Not an edge port.
Mode Interface Configuration
Usage Use this command on a switch port connected to a LAN that has no other bridges
attached. If a BPDU is received on the port that indicates that another bridge is
connected to the LAN, then the port is no longer treated as an edge port.
Example
awplus#
awplus(config)#
awplus(config-if)#
Related spanning-tree autoedge (RSTP and MSTP)
Commands
506 Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch
MSTP)
AND
configure terminal
interface port1.0.2
AlliedWare Plus™ Operating System - Version 5.4.5-0.x
spanning-tree portfast (STP)
spanning-tree edgeport
command,
C613-50057-01 REV A