Spanning-Tree Autoedge (Rstp And Mstp) - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

S T C
PANNING REE OMMANDS
- (RSTP
SPANNING TREE AUTOEDGE

spanning-tree autoedge (RSTP and MSTP)

Overview Use this command to enable the autoedge feature on the port.
The autoedge feature allows the port to automatically detect that it is an edge
port. If it does not receive any BPDUs in the first three seconds after linkup,
enabling, or entering RSTP or MSTP mode, it sets itself to be an edgeport and
enters the forwarding state.
Use this command for RSTP or MSTP.
Use the no variant of this command to disable this feature.
Syntax spanning-tree autoedge
no spanning-tree autoedge
Default Disabled
Mode Interface Configuration
awplus#
Example
awplus(config)#
awplus(config-if)#
Related spanning-tree edgeport (RSTP and MSTP)
Commands
613-50157-01 Rev C
MSTP)
AND
configure terminal
interface port1.0.3
spanning-tree autoedge
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
484