Loop-Protection Timeout - Allied Telesis IE220 Series Manual

S C
WITCHING OMMANDS
-
LOOP PROTECTION TIMEOUT

loop-protection timeout

Overview Use this command to specify the Loop Protection recovery action duration on an
interface.
Use the no variant of this command to set the loop protection timeout to the
default.
Syntax loop-protection timeout <duration>
no loop-protection timeout
Default The default is 7 seconds.
Mode Interface Configuration
Usage notes See the "Loop Protection" section in the
Configuration_Guide
information prior to applying this command.
Example To configure a loop protection action timeout of 10 seconds for port1.0.4, use the
command:
awplus#
awplus(config)#
awplus(config-if)#
Related loop-protection loop-detect
commands
loop-protection action
show loop-protection
C613-50644-01 Rev B
Parameter Description
<duration>
The time (in seconds) for which the configured action will apply
before being disabled. This duration can be set between 0 and 86400
seconds (24 hours). The set of 0 means infinity so timeout does not
expire.
for relevant conceptual, configuration, and overview
configure terminal
interface port1.0.4
Command Reference for IE220 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
Switching_Feature Overview_and
loop-protection timeout 10
532