Log Host (Filter) - Allied Telesis CentreCOM FS980M/9 Command Reference Manual

L C
OGGING OMMANDS
( )
LOG HOST FILTER

log host (filter)

Overview This command creates a filter to select messages to be sent to a remote syslog
server. Selection can be based on the priority/severity of the message, the program
that generated the message, the logging facility used, a substring within the
message or a combination of some or all of these.
The no variant of this command configures the device to no longer send log
messages to a remote syslog server. The IP address of the syslog server must be
specified. All configuration relating to this log target will be removed.
log host <ip-addr> [level <level>] [program <program-name>]
Syntax
[facility <facility>] [msgtext <text-string>]
no log host <ip-addr> [level <level>] [program <program-name>]
[facility <facility>] [msgtext <text-string>]
Parameter Description
<ip-addr>
The IP address of a remote syslog server.
level
Filter messages by severity level.
<level>
The minimum severity of message to send. The level can be specified as one of the following
numbers or level names, where 0 is the highest severity and 7 is the lowest severity:
0|emergencies
1|alerts
2|critical
3|errors
4|warnings
5|notices
6|informational
7|debugging
program
Filter messages by program. Include messages from a specified program.
<program-
The name of a program to log messages from, either one of the following predefined program
name>
names (not case-sensitive), or another program name (case-sensitive) that you find in the log
output:
rsvp
dot1x
lacp
stp
rstp
mstp
imi
613-50157-01 Rev C
System is unusable
Action must be taken immediately
Critical conditions
Error conditions
Warning conditions
Normal, but significant, conditions
Informational messages
Debug-level messages
Resource Reservation Protocol (RSVP)
IEEE 802.1X Port-Based Access Control
Link Aggregation Control Protocol (LACP)
Spanning Tree Protocol (STP)
Rapid Spanning Tree Protocol (RSTP)
Multiple Spanning Tree Protocol (MSTP)
Integrated Management Interface (IMI)
Command Reference for FS980M Series
AlliedWare Plus™ Operating System - Version 5.4.7-0.x
280