Copy Startup-Config - Allied Telesis AT-IX5-28GPX Manual

High availability, high power video surveillance poe switch

Hide thumbs Also See for AT-IX5-28GPX:

Table of Contents

COPY STARTUP

copy startup-config

This command copies the startup-config script into a destination file, or

alternatively copies a configuration script from a source file into the startup-config

file. Specify whether the destination is Flash or USB when loading from the local

copy <source-name> startup-config

copy startup-config <destination-name>

Privileged Exec

To copy the file Layer3.cfg to the startup-config, use the command:

To copy the startup-config as the file oldconfig.cfg in the current

directory, use the command:

copy running-config

Command Reference for AT-IX5-28GPX High Availability, High Power Video Surveillance PoE Switch

<source-name>

<destination-name>

copy Layer3.cfg startup-config

copy startup-config oldconfig.cfg

AlliedWare Plus™ Operating System - Version 5.4.5-0.x

The filename and path of a configuration file. This must be

a valid configuration file with a . cfg filename extension.

Specify this to copy the script in the file into the startup-

config file. Note that this does not make the copied file the

new startup file, so any further changes made in the

configuration file are not added to the startup-config file

unless you reuse this command. See

117 for valid syntax.

The destination and filename that you are saving the

startup- config as. This command creates a file if no file

exists with the specified filename. If a file already exists,

then the CLI prompts you before overwriting the file. See

Introduction

on page 117 for valid syntax.

Introduction

C613-50057-01 REV A