ADTRAN AOS Version R10.1.0 Command Reference Manual page 2268

Command Reference Guide
ipv6 access-policy <ipv6 acp>
Use the ipv6 access-policy command to assign a specified Internet Protocol version 6 (IPv6) access
control policy (ACP) to an interface. IPv6 ACPs are applied to IPv6 traffic entering an interface. Use the
no form of this command to remove an ACP association.
Syntax Description
<ipv6 acp>
Default Values
By default, there are no configured IPv6 ACPs associated with an interface.
Command History
Release 18.1
Usage Examples
The following example applies the IPv6 ACP PRIVATEv6 to the interface:
Enable the AOS security features:
(config)#ipv6 firewall
Associate the ACP with the Frame Relay subinterface 1.16:
(config)#interface frame-relay 1.16
(config-fr 1.16)#ipv6 access-policy PRIVATEv6
60000CRG0-35E
Identifies the configured IPv6 ACP by alphanumeric descriptor (all ACP
descriptors are case sensitive).
Command was introduced.
Copyright © 2012 ADTRAN, Inc.
Frame Relay Subinterface Command Set
2268